Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1841 VWIC MFT-T1 compatible w/ Voice T-1?

Had a 2801 go down for a customer w/ no immediate smartnet replacement.

trying to get a loaner 1841 up w/ a VWIC-1MFT-T1...they run 8 channels of voice to the telco...having a problem getting the voice card commands entered...

The product web site says:

The Cisco 1841 dramatically increase interface card slot performance...support WICs) and multiflex trunk cards (voice/WICs [VWICs]-for data only on the Cisco 1841 router).

Does this "for data only" part mean that I cannot connect to a Multi-flex trunk to run 8 channel of voice using the following IOS: c1841-adventerprisek9-mz.123-14.T7

I can?t get the VWIC commands to take:

Router(config-controller)#ds0-group 0 timeslots 1-8 type e&m-wink-start

%Configure network-clock-participate wic 0 first

Router(config-controller)#

?network-clock-participate wic 0? is not an option according to the IOS?????

help & thx.

244
Views
0
Helpful
0
Replies