I have a UC520 with access points. I have two ssids created on the UC520, one ssid pointed to the data vlan (1) and a voice ssid pointed to the voice vlan (100).
I want to add a new device in UC520. but looks like UC520 is missing the device type of a 7925G cordless phone. Anyone have any procedures to fix this issue?
when I tried to configure the MAC ID of 7925G & device type 7921 from CCA, It has been configured but when I exit from CCA & login again that time i am getting trouble I am unable to show that line in CCA, i tried 4 to 5 times
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...