Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

7961G firware for CUCM 6.0

we have both the 7960 and 7961 phones. They are all in the same CM groups/dial groups etc, but the 7961's will not dial out. The 7960 dials out just fine.

Is there a new firmware version for the 7961 on CUCM 6.0, or where would I fine that?

1 REPLY
Bronze

Re: 7961G firware for CUCM 6.0

Check the CSS and partition for 7961, in CUCM 6.0 check the load is present for 7961 also reboot the CCM and power cycle the IPPhone 7961.

107
Views
0
Helpful
1
Replies
CreatePlease to create content