New to using AC. It was set up for our main receptionist before I came onboard. Now, we have another receptionist answering calls on another floor. She can open the AC, but when trying to place a call, she receives the error "No lines available to place call." We are running CMBE 22.214.171.1240.
I admit that I do not even know where to begin looking. She uses a 7960G phone, with her DN as the first, then the main number hunt-group lines filling up the other spots. So I need to remove one of these lines and/or create a new line for her to use the AC through? Any help/direction would be appreciated. I've attached the ERROR portion of the log on her PC as well.
39[Thread-12]07/08 08:40:09.191 ERROR Thread-12 >>> ACClientTelephonyMgr.init(): Failed to do provider Login. com.cisco.ac.common.ACException: Unable to create provider -- connect timed out
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...