04-24-2009 04:56 AM - edited 03-18-2019 10:55 PM
Hi,
does anyone know the command to add a static ip route in CUCM 6.x...is it even supported?
Thanks
Mattias
Solved! Go to Solution.
04-24-2009 05:13 AM
It's not supported. On CUCM 6.x, you can only specify default gateway. Any routing function was performed by gateway.
Michael
04-24-2009 05:13 AM
It's not supported. On CUCM 6.x, you can only specify default gateway. Any routing function was performed by gateway.
Michael
10-27-2009 04:09 AM
Even I was looking for an answer for the same question. Thank you very much, Michael.
Thanks,
Bala.
12-15-2011 06:02 AM
Hi,
Could someone please confirm if we can add static route on CUCM 7.x series and if yes, what is the command ?
Regards,
12-15-2011 06:47 AM
Nope not possible in 7 as well.
Sent from Cisco Technical Support iPhone App
12-15-2011 07:15 AM
Hi George,
Thanks for your reply , juts to rule out this option completely, can someone please confirm if it is at all possible with any CUCM version , just wondering if latest version 8.x supports this?
Thanks in advance,
Regards,
Anjali
12-15-2011 07:37 AM
Hi Anjali,
Unfortunately no. The OS for CallManager is pretty much locked down. There are only a couple of commands that can be run from the OS level. Here is the CLI guide for the latest version of CallManager outlining what commands are available.
I am guessing if you have a specific need to route traffic, you probably will have to use route maps on the layer 3 switch.
12-16-2011 01:39 AM
Thanks for the reply George.
Much Appreciated.
Regards,
Anjali
12-16-2011 06:27 AM
If you really, really, really, really need it, take a look at
http://htluo.blogspot.com/2011/08/root-access-on-cucm-and-other-uc.html.
Michael
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide