Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
336
Views
0
Helpful
1
Replies

ATA 186 with non-Cisco Switches

m.metwally
Level 1
Level 1

‎06-16-2010 12:27 PM - edited ‎03-19-2019 01:05 AM

Dear Experts,

I have Cisco ATA 186 was connected to Cisco Switches and was working fine getting IP from DHCP from the CUCM 6 but I just migrated to Juniper Switches and ATA doesn't get IP through the new Switches.

I assigned the IP Address manually through IVR but I think I have to set the new VLAN also but I do not know How I do because it doesnot work via the new switches

Any help?

Labels:
0 Helpful
1 Reply 1

CHRIS CHARLEBOIS
Level 4
Level 4

‎06-16-2010 12:41 PM

Did you configure the ATA's initially?  I would assume that they would work with any switch.  However, perhaps them were setup on a particular VLAN and are expecting to receive an IP address on a dot1q tagged vlan.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents