Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATA 186 with non-Cisco Switches

Dear Experts,

I have Cisco ATA 186 was connected to Cisco Switches and was working fine getting IP from DHCP from the CUCM 6 but I just migrated to Juniper Switches and ATA doesn't get IP through the new Switches.

I assigned the IP Address manually through IVR but I think I have to set the new VLAN also but I do not know How I do because it doesnot work via the new switches

Any help?

1 REPLY

Re: ATA 186 with non-Cisco Switches

Did you configure the ATA's initially?  I would assume that they would work with any switch.  However, perhaps them were setup on a particular VLAN and are expecting to receive an IP address on a dot1q tagged vlan.

177
Views
0
Helpful
1
Replies