Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Attendant Console 10 Standard version - Obtaining Application User devices

Hi,

I want to test the Attendant Console 10 Standard version to my UC environment.

I created a Application Account from CUCM  with the suitable rights, e.g. CTI XXXX, Tab sync ...

And I installed the AC Std 10 Client (TSP, install the sound hardware) to the workstation, that was successful to install. but ...

Unfortunately, when I opened the AC software, I got the message as below (Obtaining Application User devices), and waited 1 - 2 hrs still cannot load in ... Why?

8 REPLIES
New Member

I checked the guide explained

I checked the guide explained the AC Std. version support the 5000 contacts only. Is it related?

New Member

For the application user

For the application user account you created, did you associate all phones with it?  I noticed on my test machine, the more phones associated with the AC user, the longer it takes for that to complete.

New Member

Hi,No, I just added the

Hi,

No, I just added the related rights to the new application user and I did not turn the default settings about the new application user.

You mean the "Available Devices"?
When I create a new Application user, that would load the available devices to this and I cannot to remove that?

New Member

You need to add the necessary

You need to add the necessary devices that you wish to monitor to the "Controlled Devices" list.

New Member

I tried to add one IP-Phone

I tried to add one IP-Phone device into the "Controlled Devices" ... But that still hold on the "Obtaining Application User devices", when I open the AC Std. client

New Member

when I opened the AC software

when I opened the AC software, I got the message as below (Obtaining Application User devices), and waited 1 - 2 hrs still cannot load in

New Member

The operator device must me

The operator device must me added to the "Controlled Device" list as well as any additional devices that you wish to monitor within the console.

New Member

I just assigned one

I just assigned one controlled device only, but when I open the AC std. client, that are handing on the Obtaining Application User devices ...

231
Views
0
Helpful
8
Replies