Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Attendant Console issue

Hello, we have CCM 6.0.1

we are being spammed with this alert

Attendant Console Server heartbeat rate below 24 beats per minute.

Current heartbeat rate is 14 beats per minute

do you know what this means?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Attendant Console issue

Hi,

AC server heartbeat low means either your AC server is getting hammered with a lot of requests, login, logout, etc, or the server on which the AC server is running on is really busy and so it is not able to give proper CPU time to the AC server service.

Try and log off a few of your AC users. If that fixes the issue than its a load problem and you might have to re-distribute the load.

If that does not work, check the server stats, especially the CPU and memory.

Thanks,

3 REPLIES
Cisco Employee

Re: Attendant Console issue

Hi,

AC server heartbeat low means either your AC server is getting hammered with a lot of requests, login, logout, etc, or the server on which the AC server is running on is really busy and so it is not able to give proper CPU time to the AC server service.

Try and log off a few of your AC users. If that fixes the issue than its a load problem and you might have to re-distribute the load.

If that does not work, check the server stats, especially the CPU and memory.

Thanks,

New Member

Re: Attendant Console issue

we don't use attendant console at all

we use UCCX and agents.

the alert is still active, if i clear the alert it will become active again. we have a few attendant console users configured but AC is not in use anymore. I'm going to check the CPU utilization and memory.

what else should I check?

thanks

Cisco Employee

Re: Attendant Console issue

Hi,

Ok, so if you are not using AC anymore, you should de-activate that service.

Thanks,

238
Views
0
Helpful
3
Replies