We are on Version 126.96.36.1995. We began to experience issues today with the console not answering calls when the operator clicks on them. We've tried to right click/answer as well. I've not been able to recreate the issue. It appears to happen at random. We are logging call volumes and type to attempt to pin down the issue. Any ideas?
This problem can be seen due to the multiple issue but most commonly it has been notice when you have codec mismatch or any share line appearence since CTI ports and CTI route point has to be the uniquie DN's and also CUxAC only support G711 due to the tsp limitation..
Verify if it is happening only with the internal call or external calls..If the problem reoccur try to capture the following detail logs to find the root cause of the issue..
Call manager trace
CTI manager traces
Make sure to note the calling party and call party number and the operator extension..
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...