automatic dial with CME

[yallies]

hello I would like to configure an automatic dial to an ip phone when I pick-up the handset from an intercom (in the street) on a CME platform.

Is it possible ans which is the config

thanks

regards

[Aaron Harrison]

Hi

The feature you are talking about is called 'PLAR' or Private Line Automatic Ringdown...

If you want to start teh automatic dial from an IP Phone, use the intercom command:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611355.html#wp1050890

Alternatively, if you have an analogue phone in the street you want to start the auto dial, set this on the voice port:

voice-port 1/0:1

connection plar 2000

Hope this helps...

Regards

Aaron

Please rate helpful posts...