08-16-2013 11:48 PM - edited 03-19-2019 07:08 AM
Hi,
I want to know someinformation about Cisco BE 6000, can it work in active/active mode?
if i have 2 Gatways with this 2 BE 6000 ,can the gateway also be in active/active mode?
08-17-2013 12:10 AM
Yes to both questions, assuming you want phones registered to both severs and calls on both gateways, otherwise, elaborate
Sent from Cisco Technical Support iPad App
08-17-2013 12:19 AM
Hi Jaime,
Thanks very much for reply but how will the BE 6000 act as active/active(as i am new to this BE 6000 so please bear with me)
and i can add both the Gateway in CCM in BE 6000 but how will my 2 Gateway know if 1st has gone down and all calls with go from 2nd gateway
08-17-2013 12:22 AM
BE6K configuration is no different from CUCM, I assume you know how to configure CUCM, if so, same thing, cluster and RG/RL.
Sent from Cisco Technical Support iPad App
08-17-2013 12:26 AM
Hi Jaime,
Thanks yea i have configured Router Gateway/Routle list but it was for 2 PRI on Same Gateway.here 2 Gateway
08-17-2013 12:31 AM
Its the same thing, either add the 2 endpoints if using MGCP, or the 2 h323 GWs
Sent from Cisco Technical Support iPad App
08-17-2013 12:41 AM
ok, so u mean if i have 2 Gateways with 4 PRI(2-2 on each of them) then i can dd all the 4 endpoints in Router Group and then sleect Circular(Algorithm) and then the Route list .......
Am i correct ?
08-17-2013 06:18 AM
Yes
Sent from Cisco Technical Support iPad App
08-19-2013 01:53 AM
Hi Jaime,
Thanks i will check it and surely reply to your post.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: