Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Berbee Bug with CM4.1.3sr3c

I was told that there was a bug ID and a workaround for a failure with "Live Paging" functionality in Berbee. Where can I find this bug id and workaround? Thx


Re: Berbee Bug with CM4.1.3sr3c

If its for the 7960 series, you have to use the newer firmware

Hall of Fame Super Red

Re: Berbee Bug with CM4.1.3sr3c

Hi Robert,

Just to add a note to Tommer's good answer;

CSCeg53517 Bug Details

Headline IP Phones fails to recieve Audio Multicast Stream and gets reset

Symptom: 7940/7960 phone resets while playing multicast audio stream

First Found-in Version 7.0, 7.1(1), 7.1(1.2)

First Fixed-in Version 7.1(1.3), 4.1(2)ES18, 4.0(02a)ES25, 3.3(4)ES47, 3.3(5)ES02, 3.3(3)ES77

This has also been observed with Berbee Informacast. During a live audio

broadcast, the originating phone places the call on hold and then resumes the

call. When the resume occurs, all receiving phones reset.

Hope this helps!


Please remember to rate helpful posts....

New Member

Re: Berbee Bug with CM4.1.3sr3c

Thanks all...Just an FYI this is the bug I was affected by. CSCsc78892. Apparently in sr3c SNMP starts before the database in the publisher. So the fix is to restart the SNMP service on publisher so it can sync with Berbee. They are supposed to fix it in the next patch.