Hi I need to change an option in my greeting call handler, and when I went there to do so I see that I see (invalid link) in red next to the option that I want to change. I'm in the caller input section and I'm looking at the number pad. No matter which number I select I get a warning box that says "No Call Handler was specified. Select a specific call handler or change Action Option" T OK then box goes away, but I am unable to make any changes. Can someone help?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...