Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bulk adding VG224 and lines

Hi All,

I have a serious problem that I need your help on.

I have 60 VG224's to add to a Call Manager 6.1 cluster along with the associated line information for each of the FXS ports.

Can someone tell me how I can do this using BAT.

3 REPLIES
Hall of Fame Super Red

Re: Bulk adding VG224 and lines

Hi Richard,

The good news here is that CCM 6.x is the first version to support the addition of VG224's via BAT. The bad news is that many of our peers have had issues with this procedure. Have a look at the two threads below for some good thoughts on resolving these problems;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc1009e

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc15749

Here are the docs for the BAT procedures;

Creating CSV Data Files for Cisco VG224 Gateways

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/6_1_1/t08gwins.html#wp1345635

Inserting Gateways

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/6_1_1/t08gwins.html

I would be tempted to open a TAC case right off to see what versions of CCM are going to work best for this, given the large number of these Gateways you need to install :)

Hope this helps!

Rob

New Member

Re: Bulk adding VG224 and lines

Hi Rob,

Thanks for the reply, I read these two threads already but I am still at a loss.

I can add a Gateway no problem, but I also need to add the line to each of the POTS interfaces on the 24 port module. There is a tab in BAT to "Add Lines" but filling this out correctly is a problem. The first column is "Device Name" what do you enter in there ?

Any assistance greatfully recieved.

Thanks Richard

Hall of Fame Super Red

Re: Bulk adding VG224 and lines

Hi Richard,

I wish that I had a great answer for you here but I don't. We don't run CCM 6.x so I can't do a test for you either :( I would think that this BAT would actually be "Add Phones" not "Add Lines" as these 24 ports are all considered phones not just lines.

The Device name is usually the Mac address of the device.

I would recommend posting a new question on the IP Telephony forum (next door), to see if anyone can truly help.

Sorry man!

Rob

150
Views
0
Helpful
3
Replies