I have Unity 5.0 Build 5.0(1) and bulk edit 4.0 build 115.
When I use the password tab to reset a range of users passwords they are not changed correctly. I have set a users password to a default of 2222 using SA and verified it was correct by logging in via the TUI. I then ran the bulk edit tool and changed this users password to 3333. Now neither password works.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.