Hello, It sounds like Unity did not keep up with the configuration change. This forum is for discussing specific defects. For troubleshooting and remediation I recommend posting to the Unity Connection forum or opening a Cisco TAC case. Regards, Wes
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.