Call Handler works w/internal calls not PSTN calls
8 FXO ports for in and out bound traffic (H323 gateway setup) outbound works fine. Inbound traffic is pointed to a Call Handler (6600), , so what I did was create a 7910 set w/ the DN 6600 CFWAll to the Voice Mail pilot . Also a Call routing rule that points forwarded calls to this call handler. Internal calls to 6600 work fine. The call viewer shows dialed DN 6600, calling station 6608, and forwarding station 6600 (all is good) now the problem, External call just ring open, but you can see the calling information on the Call Viewer What do you think is wrong Thanks in Advance
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.