Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

call remain active on FXO port after call hangs up

Hi

I have an old analog pbx

I am installing a cucm 8.0

I am installing one voice gateway CME on cisco 1900 router with fxo card

Physical conexion

Analog phone - Old analog pbx  - fxo card on cisco 1900 CME - CUCM- switch cisco  -  IP phone

Communication between Old PBX and CUCM is working but I have a problem whend I hangs up

When  I made a call, it work,  then at  the  end of call I hangs up but I  observ that the calls remain active in the voice gateway

see below

Voice-GW#show voice call status

CallID     CID  ccVdb      Port        Slot/DSP:Ch  Called #   Codec    MLPP Dial-peers

0x6        11E7 0x29742C9C 0/2/0            No DSP *5000       None      500/0

0x14       11F8 0x29745FC8 0/2/2            No DSP *5000       None      500/0

0x1C       1203 0x2974762C 0/2/3            No DSP *5000       None      500/0

3 active calls found

Voice-GW#

Is it normal ?

Why the call remain active in voice call status after hangs up ?

How can I do to remove call on active call list after hangs up ?

Regards

Everyone's tags (6)
511
Views
0
Helpful
0
Replies