Call rollover from gateway to gateway with SIP

[pbogomolnyi]

I am trying to make an outbound fax (from RightFax) roll over to GW#2 in case no PSTN trunks are available on GW#1. RightFax only supports SIP and I created a voip dial peer for destination 91T with preference 3 so it would take effect if pots dial-peers are unavailable. Debug dialpeer shows that GW#1 picks correct (SIP) dialpeer, but nothing shows on GW#2.

Any thoughts would be appreciated.

Pavel Bogomolnyi

[Brandon Buffin]

Try the following commands on GW#2:

enable

conf t

voice service voip

allow-connections sip to h323

exit

Hope this helps. If so, please rate the post.

Brandon