Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CallManager 4.1(3) dialing external Operator

I have a client that when the dial 9 for external tone and then dial 0 nothing happens. Im not sure where to enable the 0 to go to the operator of the telecom company

1 REPLY

Re: CallManager 4.1(3) dialing external Operator

Very likely Callmanager is waiting for the interdigit timeout which is 10 seconds by default. You have a few options:

1. Let your users know that they will have to wait for the interdigit timeout when dialing 0 for the operator.

2. Create a 9.0 route pattern and set the Urgent Priority flag and configure the PreDot DDI.

3. Decrease the interdigit timeout as described in the following link.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800dab26.shtml

Hope this helps. If so, please rate the post.

Brandon

119
Views
4
Helpful
1
Replies