Toll free numbers are unique in their handling requirements. If you have both local telco connections and dedicated LD connections, you will find that you can hand of *SOME* toll free traffic, but not all, on the dedicated LD circuit.
The reason for this is that unless the LD carrer you are attached to is servicing that 800 number, they will have no idea where to send it.
Toll free calls should be routed out via the LOCAL telco connection. The local telco can do a lookup to see who the toll free number is PIC'ed to, and forward it to the appropriate LD carrier for termination.
If you send it to the LD carrier, and they don't terminate that 800 number (i.e. another carrier is servicing it), you'll get the error you are describing.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.