Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot associate an ephone-dn with a FXO port

Hello,

To associate an ephone-dn with a foreign exchange office (FXO) port, I use the trunk command in ephone-dn configuration mode...but when I finish the config and press the button in my phone...anything happens..What am I doing wrong?

this is the config:

BEGIN=========================================

!Private Lines

!

!Direct 1

conf t

voice-port 0/1/0

connection plar opx 2220970

exit

!

!Dial peer to take Private Line 1

dial-peer voice 280 pots

destination-pattern 7100

port 0/1/0

exit

!

!Direct 2

voice-port 0/1/1

connection plar opx 2220973

exit

!

!Dial peer to take Private Line 2

dial-peer voice 281 pots

destination-pattern 7101

port 0/1/1

!

!!Ephone-dn to assign the private lines, the sentence "trunk" take the dial peer to send the calls to port 0/1/0

!Linea 1

ephone-dn 110

number 2220970

name "Linea Privada 1"

!invoque the destination of connection in FXO private line 1

trunk 280

!

!Linea 2

ephone-dn 111

number 2220973

name "Linea Privada 2"

!invoque the destination of connection in FXO private line 2

trunk 281

!

!Asigne the ephone-dn to the buttons, in ephone 6 the private line only in silent mode

!

ephone 5

button 1:5 2:251 5:110 6:111

!

ephone 6

button 1:6 2:250 5s110 6s111

END========================================

I need some help with this issue..

Thanks!!

2 REPLIES
Bronze

Re: Cannot associate an ephone-dn with a FXO port

To associate an ephone-dn with a foreign exchange office (FXO) port, use the trunk command in ephone-dn configuration mode. http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_t1ht.html#wp1015411

New Member

Re: Cannot associate an ephone-dn with a FXO port

Yes, I used this guide to associate the ephone, if you see the script that I published..have the same structure as examples and use the "trunk" command but When I try to take the line only have a busy tone. It is not a trunk problem because when I test the configuation I receive the incoming calls normally. The problem is I cannot use the line to make outgoing calls.

I think I associated wrong the dial-peer with the command "trunk". While I programmed I saw that the "trunk" command says nothing of its parameters that can only be of type "WORD". This is not very specific so I have doubts.

Thanks for your help!!

511
Views
0
Helpful
2
Replies
CreatePlease to create content