I am attempting to enable purging of old CDR/CAR records on my client's CallManager. However, I am unable to access the CAR tool to do so.
When I open the page, I am told that the credentials I have supplied are not valid. However, it says this before I supply any credentials. I have tried accessing the CAR tool from various workstations, as well as the Pub and Sub, but get the same thing every time. Any ideas? The overloaded databases are causing problems when BARS runs, so I'd like to get this taken care of.
Here is the art.ini config:
dn=cn=Directory Manager, o=cisco.com
passwd=[verified this is good]
I added the LDAP section after reading a few posts in the forum. It is copied verbatim from DirectoryConfig.ini. I have verified that ports 8404 and 8405 are accessible (and the default, 389, is not). I have confirmed the Directory Manager account's password is valid by logging into DC Directory Administrator.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.