03-16-2008 10:08 AM - edited 03-20-2019 05:51 AM
Hi. I have ccm6.0 and 2821 gateway with vic2-4fxo interface card. I have configure mgcp on gateway and ccm.
My config.
_______________________
!
voice-card 0
no dspfarm
!
!
control-plane
!
!
!
voice-port 0/3/0
signal groundStart
timing hookflash-out 50
station-id number 225
caller-id enable
!
voice-port 0/3/1
signal groundStart
station-id number 225
caller-id enable type 1
!
voice-port 0/3/2
!
voice-port 0/3/3
!
voice-port 2/0/0
!
voice-port 2/0/1
!
voice-port 2/0/2
!
voice-port 2/0/3
!
voice-port 2/0/4
!
voice-port 2/0/5
!
voice-port 2/0/6
!
voice-port 2/0/7
!
voice-port 2/0/8
!
voice-port 2/0/9
!
voice-port 2/0/10
!
voice-port 2/0/11
!
voice-port 2/0/12
!
voice-port 2/0/13
!
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server 10.10.18.5
ccm-manager config
!
mgcp
mgcp call-agent 10.10.18.5 service-type mgcp
mgcp dtmf-relay voip codec all mode out-of-b
mgcp rtp unreachable timeout 1000 action not
mgcp modem passthrough voip mode nse
mgcp vad
mgcp voice-quality-stats all
mgcp package-capability rtp-package
mgcp package-capability sst-package
mgcp package-capability pre-package
no mgcp package-capability res-package
no mgcp package-capability fxr-package
no mgcp timer receive-rtcp
mgcp sdp simple
mgcp validate domain-name
mgcp validate call-agent source-ipaddr
mgcp endpoint offset
no mgcp explicit hookstate
mgcp rtp payload-type g726r16 static
!
mgcp profile default
!
!
!
dial-peer voice 999010 pots
!
dial-peer voice 999030 pots
service mgcpapp
port 0/3/0
!
dial-peer voice 1 pots
!
!
!
!
gatekeeper
shutdown_______________________
When i call on call manager over port 0/3/1 my call not come on ccm/ And when i call from ip phone over port 0/3/1 call not work.
Can i fix it?
Solved! Go to Solution.
03-16-2008 11:29 AM
where's the dial-peer for 0/3/1?
i only see the one for 0/3/0
if you don't have it, then add it to the config, do a no mgcp / mgcp and try again
did you verified the endpoint status in CUCM to be registered before the test? if it shows unregistered that's why it fails
HTH
javalenc
if this helps, please rate
03-16-2008 11:29 AM
where's the dial-peer for 0/3/1?
i only see the one for 0/3/0
if you don't have it, then add it to the config, do a no mgcp / mgcp and try again
did you verified the endpoint status in CUCM to be registered before the test? if it shows unregistered that's why it fails
HTH
javalenc
if this helps, please rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide