Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME + AA

Hello

I have a problem deploying aa service on my ccme. I can't find good instructions about installing it.

my ccme is connected to PBX via fxo, and all configuration examples are with digital connection. Like this -

dial-peer voice 1000 pots

service aa

incoming called-number 8005550100

port 1/0:23

I've download tcl script and extracted it to flash memory, could you please list minimum commands that must be in my configuration for aa to answer the call.

Thank you in advance

6 REPLIES
New Member

Re: CCME + AA

Hi,

Have you been able to fix this problem? I presently have a similar situation with my AA service on CME with fxo ports.

Any body in the forum with a fix?

Regards,

Hall of Fame Super Gold

Re: CCME + AA

What problem do you have exactly ?

New Member

Re: CCME + AA

The exact problem as explained in the original post. I have a CME and have enabled AA but the AA tcl script does not kick in so I do not hear the welcome prompt and other menu. I'm using vic2-4fxo is pick the call.

Is it that AA cannot work with the analogue FXO except when you a CUE to direct the incoming calling to the inbuilt AA which has a voip dial-peer?

Regards,

Kayode

Hall of Fame Super Gold

Re: CCME + AA

B-ACD/AA can work with any type of line.

You need a DP voip with "incoming called-number XXX" where XXX is the same than in "connection plar XXX".

After that you debug the script itself with "debug voice application script" and "term mon".

Hope this helps, please rate post if it does!

New Member

Re: CCME + AA

Thanks but I've actually done all of these without success. Do you have a useful link? Which debug command can I run to verify the call progress apart from the debug voice application all?

Regards,

Hall of Fame Super Gold

Re: CCME + AA

The main document is at:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/bacd/configuration/guide/40bacd.html

Note, if "debug voice application script" produces no output, your DP config is wrong.

115
Views
0
Helpful
6
Replies
CreatePlease login to create content