cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
605
Views
4
Helpful
9
Replies

CCME feature licenc

I have CCME and I want to upgrade the "feature licens" from 24 phones to support 96 phons .

I need to know how can I double check the current licencs .

can any one advice me ?

9 Replies 9

Brandon Buffin
VIP Alumni
VIP Alumni

Do the following:

conf t

telephony-service

max-ephones ?

After typing ?, you should (1-X) where X is the maximum phones the system will currently support.

Hope this helps. If so, please rate the post.

Brandon

Dear Brandon,

Actuly I have an issue with my CCME and I am not sure if it licence issue or configuration issue.

I am unable to rigester more than 24 phones on my 2852 even after entring "max-ephones 96" in the telephony-service .

atthced is copy of my runnig config.

Rob Huffman
Hall of Fame
Hall of Fame

Hi Yousif,

Just to add a note to Brandons great info. CME Licensing is Platform Specific. Have a look at the following;

Maximum Total IP Phones (Platform Specific)

Cisco 2801

24 IP Phones

Cisco 2811

36 IP Phones

Cisco 2821

48 IP Phones

Cisco 2851

96 IP Phones

Cisco 3825

168 IP Phones

Cisco 3845

240 IP Phones

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/prod_installation_guide09186a00807aae21.html

Hope this helps!

Rob

Edit: Brandon, please keep in mind that I flunked Typing 10 (I can't keep up :)

rh

Hello

I have got the same problem.

If i Have a 2801, how i can get reister more than 24 phones?

Thanks

You cannot currently register more than 24 phones to a 2801.

Brandon

You can register 30. This is because the real limits are a little higher than the official ones.

Good point. However, I think you'll only get support for 24.

Brandon

Hi Rob,

The link is not happening, do you know where it's been moved by any chance please...?

best regards

Ajaz

Hey Ajaz,

Another broken link :(

The info is towards the bottom of the page;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/cme43spc.htm

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: