The CCNA certification for Voice has dependencies on some aspects of understanding and configuration on LAN switches; e.g the entry level device that seems to be valid towards gaining and using the switching skills to successfully be a CCNA-capable engineer seems to be based on the 1861 as a CME router.
My question is, is the switch in an 1861 CatOS or IOS based? Anything other than the 1861 in a modern design would use a LAN switch which was IOS based, not CatOS.
Is LAB work for a CCNA Voice better worked on an IOS based LAN switch than anything CatOS based?
First off, I don't know so take this with a grain of salt (I took the CCNA a long time ago) but in the field I haven't seen a Cisco switch with the CatOS in quite a while. I've worked with mostly 3000 and 2000 series switches but if the exam follows what's going on in the real world I would assume you'll be looking at the IOS and not CatOS.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...