Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCX5.0(2) - Initial Setup of CRS

Hi!

When performing first node setup procedure, after filling in the Unified Configuration Page, the Systems Parameters Configuration page does not open (it appears done at the bottom but it's all white).

What could be the problem?

Best Regards,

Ana

3 REPLIES
New Member

Re: CCX5.0(2) - Initial Setup of CRS

Ana,

An easy one to check is to make sure that if you are using IE or Firefox you have "Use TLS 1.0" checked. Typically this will manifest when pulling parameters from Communication Manager, but give it a try.

New Member

Re: CCX5.0(2) - Initial Setup of CRS

I have the same problem and tried this. It was not checked but after correcting this and restarting the setup - it did not work.

New Member

Re: CCX5.0(2) - Initial Setup of CRS

Just spoke with TAC. It seems to be a known bug related to license file without "seats".

117
Views
0
Helpful
3
Replies
CreatePlease to create content