Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CER 2.0 - RPELIN913 will not register

This is on CER 2.0 with CM 4.1.3

In the process of troubleshooting an issue with CER, I deleted and recreated the RPELIN913 PSAP call back route point. Now it refuses to register and gives a status in CM of "Not Registered"

Any suggestions would be greatly appreciated. Thanks!

1 REPLY
New Member

Re: CER 2.0 - RPELIN913 will not register

Figured it out... Must reassociate the route point with the CERUser... DUH...

155
Views
0
Helpful
1
Replies
CreatePlease login to create content