We are running CER 7.0 and have just added 3 new swtitches at one of our sites. The switches are 2960 running 12.2(55)se5. We have added the new switches to the LAN Switch Details and ran Locate Switch Port (on CER). When we look at the Switch Ports, only one of the new switches appears (in CER). We SSH into CER and can ping all of the new switches as well as ran the utils snmp get command (which ran fine). What do we need to do to get the other swith port to appear?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.