I was looking at the CER Switch Port details and noticed there is a device on one of my switches that is not showing in the CER switchport database. THe phone is functioning properly and I do not appear to be having any other problems except that when I search this MAC address in CER it returns 0 results. I've tried manually synching the database but with no luck. Has anyone else had this problem???
I have a couple questions. Is CDP enabled on the switchport the phone is connected to? If CDP is enabled do a "show cdp nei <*switchport*> detail just to confirm you see the phone's MAC address. Lastly, have you tried replacing the phone? If this is an existing switch and phones are located then there's no sign of an SNMP issue.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...