Can CER pull something like a description of a switchport?
The idea we wanted to go with, was to put the Room number in each switch port as a static entry, for IOS switches this would be in the description field. Then have CER pull the description and place that into the phone's location. Is this possible?
Use the Switch Port Details page to assign switch ports to ERLs. This assignment allows Cisco Emergency Responder (Cisco ER) to assign the correct ERL to phones that connect to the network through the configured ports.
To support switches such as the Cisco Catalyst 3750 which have ports that can be uniquely identified by Switch ID, Module ID and Port ID combination, Cisco ER 1.2(3) uses the following port naming convention:
IfName: New field display name for port as given for the switch CLI (for example Fa1/5 or Gi2/0/1)
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...