i need to know the easy way to change directory number for voice mail port number as per i have 190 port need to change just the directory number for it with the old same configureation CSS,Device Pool,.....etc
The easiest way is to delete all the ports and then use the wizard to re-create them, should not take more than few minutes. Take a note of the naming convention used for them and all the settings, delete them, use wizard and change name prefix if default was not used before as this is how UCON registers these via the name. The re-add the ports to proper Line Groups.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...