We currently have an operator hunt pilot ext 1300 with 1301-1305 hunt group members. These are taking up valuable DIDs i'd like to use for end users. So i'd like to change to 1400 with 1401-1405 as members. I've copied the setup and created a hunt pilot at DN 1400, Hunt List (currently disabled) with a new line group that includes the 1401-05 DNs. My next step will be to replace the Lines on the two operator phones with these new DNs. Aside from that and enabling the new Hunt List (disabling the old) is there anything else that would reference that old 1300 hunt pilot for incoming calls? I feel like there's an initial step that tells incoming calls to go to 1300.
We have CM 9.1.2, not using Cisco Attendant console, we use a third party attendant console (Vistapoint) but we do have a UCCX in place.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.