I would like to change the MeetingPlace 7.1 main menu prompt. I just need to remove the "To reach an assistant", "Press 0" and "Then press #" prompts at the end of the main menu prompt, we have no assistant. I see that it is series of .wav files, can I truncate the three I don't need? I see instructions to record a new prompt, hope I don't have to do that.
The prompts you're looking for are 433, 42, and 1739 and they are stored in /opt/cisco/meetingplace/application/prompts/en_US.
If you want to remove these, they can be overwritten with the silent prompt which is s214.wav. However, if you overwrite the "press 0" and "then #", they cannot be used by other MeetingPlace IVR events so this will break some functionality of the system.
It isn't possible to change the script which calls the prompts so unfortunately the only way to remove a prompt is to replace it with the silent prompt (s214.wav). This will cause problems though if you remove prompt 42 and 1739 since the system will no longer be able to play the "press 0" and "then #" in any situation.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...