You can do it from the keypad, though I know that's not what you want! I've seen scripts for configuring backgrounds by pushing key presses to the phones, but how relable it would be for something as important as this is difficult to say.
What I would say is that I really only see problems with speed/duplex settings at customer sites where they have taken to setting speed and duplex manually - it's far more common for someone to mis administer a phone or PC that for negotiation to fail these days, and I see very busy network people wasting time setting/unsetting switch ports and messing with NICs on these sites...
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
thanks for that. Yes its not ideal doing it from the phone itself
so I was hoping for an enterprise solution.
A lot of our devices were fixed 100/full so the phones being on auto is causing them all to connect half/100. Its either a case of networks changing all the phones or desktops doing all the pc's... whichever is the simpler!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...