I had to replace one of my 7931 Cisco Phones. I went into the config and just changed the MAC address from the old one to the new one and the phone registered correctly. However, The phone is not pulling the correct time. All of my other phones have the correct time but this one. Any advice would be appreicated.
I know you just replaced the MAC of the phone but did you verify that the Device Pool assigned to the phone has the correct Date and Time Group? Also verify that the NTP source that you're providing to the phones is synced.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...