Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco ASA Phone Proxy Licensing

We are installing the ASA Phone Proxy for use with about 150 remote teleworker phones. It is my understanding that the licensing is done on a per session basis. Does this per session basis refer sessions established by the phone to the ASA or from the phone to the CUCM servers. Meaning, will we need to purchase a license for each phone to call manager server session?

So if i have 150 phones and 3 call manager servers will i need to purchase 450 session licenses?

8 REPLIES
Hall of Fame Super Silver

Re: Cisco ASA Phone Proxy Licensing

You would need 150 sessions as the licesnes refers to the TFTP proxy. 1 to 1 relationship for each phone.

Chris

Community Member

Re: Cisco ASA Phone Proxy Licensing

Chris,

According to Cisco's licensing guide for this product, you specifically need one license per phone per server. It specifically says that if you have a phone with a pub and a sub, that is two licenses. So regardless of how many it will allow you to use (and I don't think it would allow you to do this), you wouldn't be in compliance with anything less than 450 phone proxy seats assuming all 150 phones were setup to use all three CUCM servers.

Community Member

Re: Cisco ASA Phone Proxy Licensing

Sorry, not related to your question but have another. Do you have it working and is tls required?

Community Member

Re: Cisco ASA Phone Proxy Licensing

Yes and yes.

Community Member

Re: Cisco ASA Phone Proxy Licensing

Thanks a bunch. I am searching high and low for doci

Community Member

Re: Cisco ASA Phone Proxy Licensing

Same Situation. Anyone know where the documentation is for this?

Community Member

Re: Cisco ASA Phone Proxy Licensing

another dumb question.

Can you set this up w/o tls to CM. In otherwords, can the tls proxy stop at the cm?

Community Member

Re: Cisco ASA Phone Proxy Licensing

@mullaneywt

you've said that you have this working right?

may I ask on what version of CM?

have anyone have it working on CM 4.1(3)? any docu for 4.1(3)?

Thanks

348
Views
0
Helpful
8
Replies
CreatePlease to create content