Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco SRST Configuration

Hi every body ,

I'm trying to configure SRST on cisco 2850  router ,

We have a PRI Linge without DID option with number : 71103300

the pb is  for the incoming calls  : the caller faces a  dial tone and the call is not transferred the extension 3078

this the print out of the dial rule 

voice translation-rule 1
rule 1 /^70103300/ /3078/
!
voice translation-rule 2
rule 1 /^02/ /2/
rule 2 /^07/ /7/
rule 3 /^09/ /9/
rule 4 /^04/ /4/
rule 5 /^05/ /5/
!
!        
voice translation-profile SRST-IN
translate called 1
!
voice translation-profile SRST-OUT
translate called 2
!

Can any one help me .

5 REPLIES
VIP Super Bronze

Re: Cisco SRST Configuration

Your incoming dial-peer needs to have the direct-inward-dial command present on it.

Please remember to rate helpful responses and identify helpful or
New Member

Re: Cisco SRST Configuration

Ok thanks Jonathan   for your help , but is there any trick or a command  to configure  without the need of the DID ?

VIP Super Bronze

Re: Cisco SRST Configuration

No and I suspect that you misunderstand what the direct-inward-dial command does. It only prevents secondary dial-tone which is what you are experiencing. The default behavior of CME when an incoming dial-peer is matched is to provide dial tone so the caller can enter the destination address they desire. This command states that whatever the destination address received when the dial-peer was matched is the destination address for the outbound call leg and does not offer additional input opportunities to the caller.

Please remember to rate helpful responses and identify helpful or
New Member

Re: Cisco SRST Configuration

I should thank you Jonathan for  your support .

Thanks   again .

New Member

Re: Cisco SRST Configuration

Hello ,

My friend found a slution without the need of DID , you can find  here the command

voice translation-rule 1
rule 1 /^.*/ /3078/
!

Have a  nice day .

1468
Views
0
Helpful
5
Replies