Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Unified Call Manager Express 4 w/NM-CUE

Trying to call forward "ALL" calls from a 7970-G phone via softkey to a outside number over the FXO module. After AA answers and sends call to extension, the phone rings twice and then send the call to a womans voice, not sure where the womans voice is coming from. It does state that I "don't have to dial a one before calling this number".

It works fine if I send the local call out my long distance SIP provider, but I would rather not have all the local calls going out LD. I am trying to send out all 352 area code numbers and have 4 active incoming/outgoing lines for local calling to my direct PSTN.

Config below, Thanks for any suggestions but I can't figure this out and I know someone probabaly ran across this before.

PART OF THE CONFIG CISCO CONFIG:

----------------------------------

translation-rule 9

Rule 0 ^90 0

Rule 1 ^91 1

Rule 2 ^92 2

Rule 3 ^93 3

Rule 4 ^94 4

Rule 5 ^95 5

Rule 6 ^96 6

Rule 7 ^97 7

Rule 8 ^98 8

Rule 9 ^99 9

!

voice-port 0/1/0

supervisory disconnect anytone

ring number 2

connection Tie-line 2001

caller-id enable type 2

!

voice-port 0/1/1

supervisory disconnect anytone

ring number 2

connection Tie-line 2001

caller-id enable type 2

!

voice-port 0/1/2

supervisory disconnect anytone

ring number 2

connection Tie-line 2001

caller-id enable type 2

!

voice-port 0/1/3

supervisory disconnect anytone

ring number 2

connection Tie-line 2001

caller-id enable type 2

!

dial-peer voice 10 pots

destination-pattern 9352T

translate-outgoing called 9

port 0/1/0

forward-digits 7

!

dial-peer voice 11 pots

destination-pattern 9352T

translate-outgoing called 9

port 0/1/1

forward-digits 7

!

dial-peer voice 12 pots

destination-pattern 9352T

translate-outgoing called 9

port 0/1/2

forward-digits 7

!

dial-peer voice 13 pots

destination-pattern 9352T

translate-outgoing called 9

port 0/1/3

forward-digits 7

!

112
Views
0
Helpful
0
Replies
CreatePlease to create content