Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CM 6.1.1 with LDAP Integration

We have integrated Communications Manager 6.1.1 with the Active Directory LDAP. When we select the Corporate Directory and search for a user. The Phone number that appears is 10-digit. Of course when the employee selects the number, the call fails. How do we force the LDAP directory to return the Employees internal 5-Digit Extension?

4 REPLIES
New Member

Re: CM 6.1.1 with LDAP Integration

Hi,

You can't force AD to change the number.

2 ways to do this:

1. Write a script to pull out the 10 digit numbers, convert them to 5 digit numbers and push them into the ipPhone attribute (assuming the 10 digit is in the telephoneNumber attribute). Then sync CCM against the ipPhone attribute.

2. Add translation patterns into CCM that will change the 10 digit number down to a 5 digit number.

Ken.

New Member

Re: CM 6.1.1 with LDAP Integration

You can configure the LDAP search field to use the IPPhone instead of the Telephonenumber field under the user properties (win 2003), LDAP will point to this field and the CDirectory will show the 4 or 5 digit ext.

hth

Armando

New Member

Re: CM 6.1.1 with LDAP Integration

Where would you configure this to pull from the IP Phone field?

Re: CM 6.1.1 with LDAP Integration

Hello,

Go to system--->LDAP---->LDAP Directory

You will have to delete and recreate the current LDAP directory configuration or add new. Then go down to the section that says "User Fields to be Synchronized". There you can set the phone number field in call manager to pull from the ipPhone field in AD.

Hope that helped, if so please rate.

361
Views
0
Helpful
4
Replies
CreatePlease login to create content