CME 40 call transfer isdn to isdn: how to configure it
I have a single 2611XM with two BRI interfaces. I want to be able to transfer external calls back to ISDN (hairpin). All my configuration attempts have failed so far. I always get a fast busy signal after dialing the last digit of the external number.
I have set a transfer-pattern .T, another equaling my external number. I have tried all transfer system types, no sucess at all.
when debugging dialpeers I do not see any output while typing in the transfer number, the same result with debug voice ccapi inout.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...