Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CME - how keep the MWI status when reload

I have CME-CUE installatoin and have a question how CME keeps the MWI stauts when relaod. I can see the MWI flag ON when I leave a voice mail in CUE but it gone when I relaod the CME and ON again when I issue the command 'mwi reflesh all' from CUE. I don't see a MWI resync scheduling option in CUE so no way to update the MWI status to CME until run the command 'mwi reflesh'

Advise please,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CME - how keep the MWI status when reload

What MWI method are you using? If you use sub-notify, it should work. Basic outcall MWI won't because there's no real state. The CUE will just send MWI when it gets a new message or someone checks messages.

2 REPLIES
Cisco Employee

Re: CME - how keep the MWI status when reload

What MWI method are you using? If you use sub-notify, it should work. Basic outcall MWI won't because there's no real state. The CUE will just send MWI when it gets a new message or someone checks messages.

Community Member

Re: CME - how keep the MWI status when reload

Thanks Markus,

Can I use the 'sip-ua' in SRST-CUE integration model?

John

334
Views
0
Helpful
2
Replies
CreatePlease to create content