Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME off-hook dial

Hello,

I have this scenario:

Analog Phone----VG224----2851CME----IP Phone

I need the analog phone to dial a CME ephone-dn as soon as it goes off-hook. VG224 registers thourh SCCP with CME and I get a dial tone on the analog phone, but I want that phone to dail an extension when it goes off-hook.

I've read that with CCM you configure a blank pattern and assign that pattern to a CSS so when it goes off-hook it will dial the masked number. But how do I do this in CME since CSS don't apply?

2 REPLIES
Blue

Re: CME off-hook dial

In short, Yes.

You can use SCCP controlled FXS/Analog PLAR on the vg224 to accomplish what you need.

Please see the following link for more info on SCCP FXS PLAR:

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html#wp1299823

See the following link, from same document, on PLAR configuration for your SCCP controlled vg224 FXS:

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html#wp1291125

New Member

Re: CME off-hook dial

On the CME router under the dial-peer for the analog VG224 port configure the plar command to send the call to the apporpriate destination. IE:

dial-peer voice 1 voip

connection-plar 4300 (version dependant)

344
Views
0
Helpful
2
Replies
CreatePlease login to create content