Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME - unable to configure H.323 gw using ipv6 address

Hi All

I have installed Call Manager Express 8.0 in 2811 Router and trying to interconnect with other Call Managers using IPV6.

CME works fine in dual stack made with both IPV4 & IPV6 address with the internal network. While trying to connect other Call Manager,I have configured the H.323 Gateway using IPV4 address and i can dial out the numbers.. 

Since we are functioning this Call Manager in IPV6, i tried configuring the H.323 Gateway using IPv6 address but there is no option to configure IPV6 IP in the "voip bind srcaddress <ip>". Can anyone tell me is it possible to do it & which CME version support ipv6.

Regards,

Lavanya

Everyone's tags (2)
404
Views
0
Helpful
0
Replies