cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
385
Views
0
Helpful
1
Replies

Configuration problem w/ incoming call

n3tw0rker
Level 1
Level 1

Hello there, just new here and w/ cisco CCME version 4.0

My scenario is, we have a C3845 named PBX01 w/ CCME v 4.0 connected to PSTN and C3845 named PBX02 w/ 7911G ip phones connected (local numbers are 1...) to it.

I want to configure local number 1038 to receive an incoming call from PSTN 701102001. the IP phone local 1038 is connected to PBX02. What i did is configured the translation-rule from PBX01 to translate incoming 701102001 to 1038 and point it to PBX02. when i test it by calling from outside, the local 1038 is ringing but i can't hear a dtmf tone and when the phone is pick up the connection is cut or we can't hear each other. I already included a voice class codec configuration on my dial peers but it is still not working. Pls check my attached file w/ includes some of my config in PBX01 and PBX02.

Pls assist me if my configuration in Translation-rule, in voice class codec and dial peers are correct.

thanks

1 Reply 1

n3tw0rker
Level 1
Level 1

For PBX01:

translation-rule 1

Rule 1 ^701102001 1038

voice-port 1/0/0:15

translate called 1

!

!

!

!

!

dial-peer voice 1038 voip

destination-pattern 1038

session target ipv4:10.10.254.1

dtmf-relay h245-signal h245-alphanumeric rtp-nte cisco-rtp

!

dial-peer voice 701102001 pots

destination-pattern 701102001

translate-outgoing called 1

incoming called-number 701102001

direct-inward-dial

port 1/0/0:15

!

dial-peer voice 10 voip

destination-pattern 1...

session target ipv4:10.10.254.1

dtmf-relay h245-signal h245-alphanumeric cisco-rtp

!

!

!

!

!

call-manager-fallback

max-conferences 12 gain -6

transfer-system full-consult

!

For PBX02:

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

codec preference 3 g729br8

!

!

dial-peer cor custom

name 9T

name 1...

!

!

dial-peer cor list moi-VIP

member 9T

!

dial-peer cor list moi-Local

member 1...

!

!

!

dial-peer voice 10 voip

destination-pattern 1038

voice-class codec 1

session target ipv4:10.10.254.1

!

dial-peer voice 10 voip

corlist incoming moi-VIP

corlist outgoing moi-Local

voice-class codec 1

session target ipv4:10.10.254.1

dtmf-relay cisco-rtp h245-alphanumeric h245-signal rtp-nte

!

ephone-dn 38

number 1038

caller-id block

corlist outgoing moi-VIP

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: