Hi, I have some confusion on configuring SNMP and Trap notifications to a network monitoring box we have. When I enter Unified Serviceability and go to SNMP Notification Destination Configuration and try to set up the trap notification, it asks for a community name and does not pick up the one I have already configured called public. If I then create a new community name from that screen called public it says it has created it on nodes that have not had it configured before, this sounds right but it still does not show up in the drop list for me to pick to finish the configuration of the trap. I am not sure if it is working or not. Can someone help me and maybe show me a way to send it a test trap to verify it is working?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...