I am helping a customer with their CUC upgrade. For some reason (either something happened during the upgrade, or some interns accidentally set some users incorrectly) to the wrong timezone.
What I am looking for is a way to dump the subscriber database by the users time zone setting. Foe example this morning I found a couple users in Chicago that were set to Australia/Eucla. Given that there are about 7,000 subscribers on this system going thru manually and looking for anomolies isn't a very attractive option.
Anyone know how to get a list filtered by time zone so we know where to focus because we dont have any facilities in those locations?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...