Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

connection plar problem with cue and srst

i don't know, but it seems i made a stupid mistake somewhere in my config.

i have this router that works fine when it's connected to my callmanager

and when i disconnect network for srst test , it goes to fallback and everything works fine but if i call the fxo port it will not transfer to my AA in my CUE

i tried with connection plar opx and AA didn't pickup the line and when i tried with connection plar i heard busy signal.

i attached config file

any help would be appreciated

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: connection plar problem with cue and srst

Hi,

You could try these additional lines depending on your IOS level.

For IOS 12.3(13)T or earlier

use

!

!

config#call application alternate default

!

!

For IOS 12.3(14)T or later

use

!

!

config#application

(config-app)#global

(config-app-global)#service alternate Default

!

!

These commands hand the service to DEFAULT when MGCP is not available.

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080144630.shtml

Hope this helps

Alex

Regards, Alex. Please rate useful posts.
2 REPLIES
Green

Re: connection plar problem with cue and srst

Hi,

You could try these additional lines depending on your IOS level.

For IOS 12.3(13)T or earlier

use

!

!

config#call application alternate default

!

!

For IOS 12.3(14)T or later

use

!

!

config#application

(config-app)#global

(config-app-global)#service alternate Default

!

!

These commands hand the service to DEFAULT when MGCP is not available.

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080144630.shtml

Hope this helps

Alex

Regards, Alex. Please rate useful posts.
New Member

Re: connection plar problem with cue and srst

Thanks for help

worked!!!

appreiated

216
Views
5
Helpful
2
Replies